Entertainment Center 
          Instructions
              June 2022
                              TV Connections
                                                                        USB 1
                                                                        USB 2
                      Audio                                               HDMI 1 Cable
                      Optical                                             HDMI 2 DVD
                                                     HDMI 1-4   RF Ant    HDMI 3 PC
                                              Connect Box
                                                    Power
                                          Ethernet
                                              Power AMP
                                       Left      Power     Right
                 PA System Instructions
                        Examine speakers to ensure they are safely attached
                   Open Credenza doors to ensure equipment does not overheat
                Turn on as needed TV & DVD, then PA Power Strip, then Power AMP
                                  Ensure all devices are powered on
                              Use Power AMP to control ROOM Volume
               Left and Right Volume Must Match, turn down to 9 o’clock when done
                        When done turn off All power including Power AMP
                CAUTION DO NOT use microphones closer than 15 feet to speakers
       Wireless Microphone Use
               • Shure BLX2/PG58
               • Unscrew Bottom
               • Press Power Button
               • Select channel and Group to match 
                Channel and Group on receiver in 
                cabinet
               • Look at receiver battery light & make 
                sure it is green or replace batteries
               • Use rechargeable batteries because they 
                only last for 1 or 2 meetings
         Turn off MICs when done or batteries will fail
              Wearable Microphone Use
                               • Shure BLX1
                               • Press Power Button at top
                               • Open compartment
                               • Select channel and Group to match 
                                Channel and Group on receiver in 
                                cabinet
                               • Look at receiver battery light & make 
                                sure it is green or replace batteries
                               • Use rechargeable batteries because they 
                     Volume     only last for 1 or 2 meetings
                               • Turn downvolume to stop feedback
                 Turn off MICs when done or batteries will fail
       Microphone Use Receiver
     • Microphones must connect to receiver using the correct 
      Group and Channel
     • There are 2 receivers, 1 for each Mic
     • Use Receiver # 2 for the wearable wireless mic
               They are always on
                     System Configuration
                      Wired Mics  DVD
              Wireless Mic 1                              AMP
              Wireless Mic 2
                External 1                         Speaker L Speaker R
                                 YAMAHA
                        Volume Controls
                         USE AMP TO CONTROL ROOM VOLUME
                                 Left        Right
                       Wireless
                       Mic 1&2
                                 Wired       Master
                                 Mics    DVD
               Power AMP
            USE THIS TO CONTROL ROOM VOLUME
            CH A & B must match: 9 to 11 o’clock
                             Input
        Stereo               CH A & B from
                             YAMAHA Mixer
         Lift                Output
                             Speakers Polarity 
                             Must Match 
     Caution: Do Not bridge. This can damage the speakers with excessive power.
                           Wireless      From DVD         To
                             MICs                     Power AMP
      1/L & 2/R Settings                                                 YAMAHA
           MUST match                                                      Mixer
               PAD 1 Up
               PAD 2 Up
             HPF1 Down                                              Red Button
             HPF2 Down                                              Phantom Up for OFF
          Gain 12 o’clock
     High +15 DB o’clock                                            Power on / off
           Low 2 o’clock
           Fx1 Down ON                                              Meter Set -3DB all devices
           Fx2 Down ON                                              Start with TV
       Mono/ Stereo UP
                                                                    Master Volume 3 o’clock
    Mic Level 1 2 o’clock
    Mic Level 2 2 o’clock                                           Headphones 0
                                                              FxReturn Level 11 o’clock
                                      Level 3/4 2 o’clock
                                      Level 5/6 0 Not Used    Delay Down, VO. Echo
       Speakers
   Sound System Power
    Turn off when done!